Description
Mosfet Heat Bed Power Module Add-on Hot Bed Mosfet MOS Tube High Current Load Module for 3D Printer Hot Bed/Hot End can be used in both the Chitu motherboards and other open 3D printer motherboards. This high-power module is a general add-on heated bed power expansion module for 3D printers. It can work with the Anet A8. When using a heated bed 3D printer for a 12V power supply which may cause excessive current during times, this module, it can well protect the connectors on the controller board from burning. Completely solve the hot bed power is too large and the load current issue. Mosfet Heat Bed Power Module Add-on Hot Bed Mosfet MOS Tube High Current Load Module for 3D Printer Hot Bed/Hot End helps your 3D printer equipped with the Chitu controller board (capable of max 15A) become even more powerful. With this add-on module to the board leads the maximum current up to 25A. This module is based on power MOSFET and will allow PID control of the heated bed (DC-DC Relays usually do not allow this).
How do you install an external module?
As these boards are made for 3D printers, the installation process for them is very simple. Once you have connected the control wires, you will need to connect the DC +/- terminals to your printer’s power supply. This is where you will want to use wires with a crimped connection as opposed to bare wires to reduce the risk of any short circuits.
Next, insert you heated bed or hot end wires into the terminals labeled “HOTBED” and you’re all set. We would also recommend you use crimp terminals for the end of the wire that goes to the MOSFET as its screw terminals are better suited to these connectors.
Features of Mosfet Heat Bed Power Module Add-on Hot Bed Mosfet MOS Tube High Current Load Module for 3D Printer Hot Bed/Hot End:
- Product Name: Mosfet Heat Bed Power Module Add-on Hot Bed Mosfet MOS Tube High Current Load Module for 3D Printer Hot Bed/Hot End
- Chip Set: 210NO6 Powerful MOSFET
- Operating Voltage: 12V ~ 24V
- Max Current: 25A
- Power Rating: 300 Watts
- Compatible: RepRap, Creality CR-10, Anet E10
- Mounting holes: 3.2mm
- Screw Diameter: M3
- Length: 60 mm
- Width: 50 mm
- Height: 32 mm
- Weight: 35 gm
Package Contains :
1 x Mosfet Heat Bed Power Module Add-on Hot Bed Mosfet MOS Tube High Current Load Module for 3D Printer Hot Bed/Hot End
For more 3D Printers and Parts , click here
For Contact Info : Click here
Follow us on facebook, click here